Dr. Taylor's Support Forums

You are not logged in.

#1 2007-05-14 22:22:37

taylor
Professor
From: Milwaukee, WI
Registered: 2004-08-30
Posts: 266
PM  Website

Problems with GCC and Lab 8

One of you wrote:

After installing the file, it still doesn't work. My computer is still
locking up every time I try to build it. The worst part about this is,
every time it locks up, it won't ever reload the files. If I try to open
the project, it will freeze up again. I just don't know what I can do.

I realize that this must be very frustrating for you.  Thanks for your patience with it.  The symptoms you have are just like those of another student who was in my office today.

I wasn't able to figure out how to get there computer to do the right thing either.  I would suggest writing the code as best as you can without being able to compile it.

I'm aware of the problems you and others are having.  At this point I don't think there is much to be gained from continuing to fight with it.  Just submit what you come up with and I will grade it with that in mind.  If you would like until tomorrow at 11pm, you may have it.

I hope this is an acceptable solution for you.

Offline

 

Board footer

This website is not owned or managed by the Milwaukee School of Engineering.

© 2001-2007 Dr. Christopher C. Taylor, et. al., • Office: L-343 • Phone: 277-7339 • npǝ˙ǝosɯ@ɹolʎɐʇ